4" bolt too short for extruder?
The 4" 5/16 bolt I got for the extruder seems short. Did I print the wrong extruder body or gear? [attachment 14962 4_inch_extruder_bolt]
View ArticleRe: 4" bolt too short for extruder?
Strange. Four inch is just long enough to get the nut on about 3/4 of the nuts threads for me. I normally use 4-1/4" though because it has more threads and just fits without hitting the motor. Do you...
View ArticleRe: 4" bolt too short for extruder?
The bolt is 4" from the bottom of the head (with the head it's 4 5/32"). I don't have any washers and the bearings sit well in their sockets. I'll check the measurement of the printed part against the...
View ArticleRe: 4" bolt too short for extruder?
I can't find any 4 1/4" bolts (unless if I buy 100 pcs), but got some 4 1/2" at the hw store. Little long but I'll shim it with some washers. Will be easier to hob further from the head, too, so it...
View ArticleRe: 4" bolt too short for extruder?
Yes I have threaded one further and cut off the excess because the 4-1/4 are special order here as well.
View Article
More Pages to Explore .....